Saturday, October 24, 2009 10:01 AMI had an M1000 modem from qwest before and my server worked just fine and remote acess was not a problem. I used the prior modem simply as a passthrough, however, I can't do that now because when I try it brings my 20mb conn down to 3mb.... So, when I try using the POS Qwest Actiontec Q1000 modem, It absolutely refuses to correctly forward the ports.... I set it up and nothing happens, instead when i acess my remote site through the web it gives me the prompt as logging in the Q1000 modem... Its complete instanity. I have upgraded the firmware and have tried disablign uPnP as some websites said, but that didn't work....
Saturday, October 24, 2009 1:28 PMModeratorYou should check with Qwest or Actiontec on how to properly configure your modem. For example, Qwest has a support page specifically for this device.
I'm not on the WHS team, I just post a lot. :)
- Proposed As Answer by Ken WarrenMVP, Moderator Saturday, October 24, 2009 1:28 PM
Saturday, October 24, 2009 3:40 PMI've tried, I have port forwarding setup correctly... Qwest only cares about if you can surf the web on one computer or not, which to me is pretty useless :/
Tuesday, November 10, 2009 8:51 PMIt sounds like you have remote management turned on. I'd try turning that off (both remote gui and telnet)
Tuesday, November 01, 2011 6:57 PMTHis is an old post, but I have the same problem. Was there a solution to this?
Saturday, May 26, 2012 2:13 PM
THis is an old post, but I have the same problem. Was there a solution to this?
I'm having the same problem as well. Q1000 Actiontec modem via Qwest with latest firmware updates and I can not RDP to my WHS 2011. I've disabled uPnP and forwarded ports 80, 443, 4125. No luck, I found a couple of other sites that recommended forwarding ports 52125 & 3389 as well, but that still doesn't work. My WHS does have a static IP and I am connected via homegroup and can browse all of the libraries on the server.
Any ideas or resolutions?