How can I use the UMXdot11.exe and UMXSDRab.exe to implement the real-time communication between two sora stations?
-
20 April 2012 1:25
Hello, everyone.
I notice that UMXdot11.exe cannot be used to communicate with other Sora Station. The orders I used is as follows:
-dut start
-%Sora_path/UMXdot11.exe tx/rx
Is there someone can tell me What I have missed?
By the way, the UMXSDRab.exe has the same problem. The two sora stations have been set to be Ad hoc mode and client mode, respectively. But the association state in both of them is "No association".
How can I implement the the real-time communication between two sora stations in UMX mode? Hope for your useful reply.
Semua Balasan
-
20 April 2012 3:35
HI:
Maybe U should configure the umxdot11.ini file first.
And I found that two sora can communicate in 11b protocol but not in 11a.
Hoping helpful.
-
20 April 2012 18:32
It might be the problem of tx and rx gain setting. Once they have been properly set, it provides a simple way that shows two SORA nodes communcate with each other.
Before using UMXdot11.exe, run hardware verification tool (HWVeri.exe) first and find parameters that two SORA communicate well. After that, if you run UMXDot11, probably you will see that it succeeds to communicate.
- Diedit oleh Sangki Yun 20 April 2012 18:33
- Diedit oleh Sangki Yun 20 April 2012 20:33
- Ditandai sebagai Jawaban oleh Jiansong zhangMicrosoft Employee, Moderator 30 April 2012 3:08
-
23 Mei 2012 1:39
Hi,fuuc,
I have the same situation to rainflow. I use the command
-dut start
-%Sora_path/UMXdot11.exe tx/rx
but the output is receive 0 correct frame, and the throughput is 0.000Mbps.
Could you tell me what is your cmd command to use umxdot11.exe? And what is your cmd output?
Hope for your reply.
-
23 Mei 2012 2:32
Problem resolved.
And it also can work in 11a.
