Accedi
Microsoft.com
 
Microsoft
 
 
 
Microsoft >
> 
> 
Problem with Qwest Actiontec Q1000 modem.

Proposed Answer Problem with Qwest Actiontec Q1000 modem.

  • sabato 24 ottobre 2009 10:01
     
     
    Registrati per votare
    0
    I had an M1000 modem from qwest before and my server worked just fine and remote acess was not a problem.  I used the prior modem simply as a passthrough, however, I can't do that now because when I try it brings my 20mb conn down to 3mb....  So, when I try using the POS Qwest Actiontec Q1000 modem, It absolutely refuses to correctly forward the ports.... I set it up and nothing happens, instead when i acess my remote site through the web it gives me the prompt as logging in the Q1000 modem... Its complete instanity.  I have upgraded the firmware and have tried disablign uPnP as some websites said, but that didn't work....

    Any ideas?
     

Tutte le risposte

  • sabato 24 ottobre 2009 13:28
    Moderatore
     
     Risposta suggerita
    Registrati per votare
    0
    You should check with Qwest or Actiontec on how to properly configure your modem. For example, Qwest has a support page specifically for this device.
    I'm not on the WHS team, I just post a lot. :)
     
  • sabato 24 ottobre 2009 15:40
     
     
    Registrati per votare
    0
    I've tried, I have port forwarding setup correctly... Qwest only  cares about if you can surf the web on one computer or not, which to me is pretty useless :/
     
  • martedì 10 novembre 2009 20:51
     
     
    Registrati per votare
    0
    It sounds like you have remote management turned on. I'd try turning that off (both remote gui and telnet)
     
  • martedì 1 novembre 2011 18:57
     
     
    Registrati per votare
    0
    THis is an old post, but I have the same problem. Was there a solution to this?
     
  • sabato 26 maggio 2012 14:13
     
     
    Registrati per votare
    0
    THis is an old post, but I have the same problem. Was there a solution to this?

    I'm having the same problem as well. Q1000 Actiontec modem via Qwest with latest firmware updates and I can not RDP to my WHS 2011. I've disabled uPnP and forwarded ports 80, 443, 4125. No luck, I found a couple of other sites that recommended forwarding ports 52125 & 3389 as well, but that still doesn't work. My WHS does have a static IP and I am connected via homegroup and can browse all of the libraries on the server.

    Any ideas or resolutions?