domenica 27 marzo 2011 19:41
Hello and thank you for reading my post. My question is to ask for help with an iSCSI setting. Here is what I am doing
1) Remote console into my WHS Server
2) Launch the iSCSI Initiator
3) Click on the Targets Tab which shows iqn.2005-06.com.datarobotics:drobopro.tdb105140417.node0 as connected
4) Click the "Log On"
I am presented with a dialog box with the choice of Automatically restore this connection. When I put a check box in that box and select OK, I get a message that says
"The target has already been logged in via an iscsi connection"
My issue is that I have a DroboPrp connected via iSCSI and is Drive E: on the server. if I set up a share on the drobo like E:\Movies, when I reboot the server the shares are lost. Drobo tells me this is an iSCSI setting but Microsoft wants $75.00 for a product support call so I thought I would see if I could get some help here.
Keywords : WHS, SP2, ISCSI, DroboPro, Shares
Tutte le risposte
giovedì 31 marzo 2011 17:50Before you can edit the proprties on an iscsi connection you have to log off the session, make your changes and then reconnect
venerdì 1 aprile 2011 19:59
Tom - Thank you for the reply. Do I log off in the iSCSI properties or somewhere else? I ask because as shown in my post, I do see a LOG ON option but not a LOG OFF option inthe iSCSI configuration screens
Thanks so much
sabato 2 aprile 2011 09:24in the iscsi config screen, select the target tab. this shows your session and your tartget status as connected. Select the target by clicking on it then click on the details button. This brings up the properties page. Select the session and click on the log off button. You can then edit the properties.
martedì 5 aprile 2011 05:26
Thanks for the help. When I follow your instructions I get a message that says "The session cannot be logged out since a devise on that session is currently being used" I will reboot the server without it being connected and see what I can do.
Thanks so much
lunedì 18 aprile 2011 18:20I wanted to post a reply that I am still having an issue. I even contacted Miscorostf tech support. It took about an hour for the Microsoft support technician and I to figure out how to log the Drobo pro off so we could set up persistant connections and we rebooted the server and my shares on E:\remained but then this weekend, my WHS server rebooted following some software updates and again, all my shares were gone
venerdì 25 maggio 2012 15:16
I am seeking solution to this problem you once had. If you have solved it, can you publish how you got it solved?
I have 2 DroboPro units. Whenever the server reboots, only one of the units gets reconnected. The other unit stays offline.