IT プロフェッショナルのための技術情報サイト >
フォーラム ホーム
>
Windows Home Server Software
>
WHS Connector intall error - Unable to connect to your home server
WHS Connector intall error - Unable to connect to your home server
- Help! I can't successfully complete the WHS install. I get through much of the install and then run into the error "Unable to connect to your home server". I've followed as much of the trouble-shooting as I can, but haven't made progress.
When I run the advanced trouble-shooter toolkit, I pass all 5 network connectivity tests, but run into problems on the Server Discovery tests. I get the following log message.
[3]081230.150030.8906: Network: Test Locate Server by UPnP protocol begin.
[8]081230.150030.8906: Network: Discovering server using UPnP protocol ...
[8]081230.150040.8906: Network: Succeed. 1 Servers are found.
[8]081230.150040.8906: Network: Server name HPSERVER, IP 192.168.1.111
[8]081230.150040.8906: Error: Could not find the server in the discovered server list by UPnP protocol.
[3]081230.150040.8906: Network: Test Locate Server by UPnP protocol end.
[3]081230.150040.8906: Network: Information for test Locate Server by UPnP protocol:
I'm guessing it is a firewall config problem, but not sure. I'm running XP SP2. Windows firewall is disabled. I'm running CA Personal Firewall using the lowest protection level within the Safe Zone. I have a Linksys WRT350N router.
Any help would be greatly appreciated!!!
回答
- Martin - thanks for the help. I was able to get everything installed. I disabled the firewall during installation, but the root cause ended up being adding the fully qualified server IP in the host file. I contacted HP WHS support and they were extremely knowledgable and helpful.
- 回答としてマークBrianOlson25 2009年1月6日 1:09
すべての返信
- Why don't you disable the CA firewall for a test?
Most often personal firewalls only create more problems...
Regards
Martin
LightsOut - Power Management for Windows Home Server http://www.home-server-blog.de/add-ins/lightsout/#en - Martin - thanks for the suggestion. I have tried that before, but tried it again just to be sure. No change. :-(
- Brian,
can you connect other client machines?
Regards
Martin - Brian, I'm going to suggest you completely uninstall your third party firewall, then see what happens when you try to install the connector.
I'm not on the WHS team, I just post a lot. :) - Martin - thanks for the help. I was able to get everything installed. I disabled the firewall during installation, but the root cause ended up being adding the fully qualified server IP in the host file. I contacted HP WHS support and they were extremely knowledgable and helpful.
- 回答としてマークBrianOlson25 2009年1月6日 1:09
