A problem in user-mode of sora 1.6 version
-
28 kwietnia 2012 03:19Hi, I ran the codes of UMXDot11 of sora 1.6 version. Though the two sides can do successful communication,I can't detect the signal in Spectrum Analyzer,why? How should I use Spectrum Analyzer in user-mode?
Wszystkie odpowiedzi
-
30 kwietnia 2012 03:01Moderator
Hi zjutk,
Your question is not clear enough to me. Could you specify what your "Spectrum Analyzer" is, a real spectrum analyzer device (different from Sora device) or a Sora program?
-Jiansong
-
30 kwietnia 2012 03:41Moderator
If the problem is that you cannot run two UMX programs simultaneously (you can further check by using other Sora programs), it's the problem of your firmware version. If you need to upgrade your firmware, please contact us by email (soraord@microsoft.com).
-Jiansong
-
2 maja 2012 06:15
Thanks! The Spectrum Analyzer is a real spectrum analyzer which is named ROHDE&SCHWARZ. It is different from Sora device,and it uses it's own antenna to detect signal .We have two computers that run the codes of UMXDot11 of sora 1.6 version,and one sends signal,
the other recevie the signal .From the recevieing computer, I can see the successful receving result. However, when I use the spectrum analyzer ROHDE&SCHWARZ to detect the signal near the recevieing computer , I can't detect the signal. Is it the reason that the signal is a bursted signal? If so, how should I use the spectrum analyzer to detect the signal ?
- Zmodyfikowany przez zjutk 2 maja 2012 07:38
-
5 maja 2012 03:40Moderator
I think you should keep the sender transmitting packets and guarantee the tranffic load is high enough. Otherwise, the wireless signal may be not dense enough (in time domain) that your spectrum analysizer may miss the signal.
-Jiansong
- Oznaczony jako odpowiedź przez zjutk 11 maja 2012 01:05
-
6 maja 2012 23:41
As Jiansong suggested, your sweep time might be too slow to detect a transmission. Try increasing it (generally by reducing span/increasing RBW). Turning on max hold may help. Also check that the spectrum analyser's front-end LNA is enabled if you are trying to detect a transmission over-the-air.
-
8 maja 2012 01:19
hi, @Jiansong zhang,
What will happen if there is sth wrong with the firmware. Currently I haven't met that problem though.
PS: Can I use @ to call somebody in the forum?
Thanks a lot!
Jaimie
-
11 maja 2012 01:07Thanks！
