Can't Change Target Hard Drive RRS feed

  • Question

  • Help!  I've recently added a new external hard drive as the old one was too small.  I originally set up the first one as drive F: and it worked fine until I began using it as photo storage.  So I bought a new one and the back up configurator recognizes it ast drive J:.

    I've gone into the backup configuration section and changed the target drive to J:.  I've even followed Stephen's instructions in the Sticky about reseting back up plan settings.  When I save the new plan, the data on the screen indicates that it will save the backup to drive J:, however when I run the backup, it still goes to F: and indicates there is not enough room on F:  (which I knew).

    SO, how do I get this to work.

    Thanks in advance.

    Ole Joe 

    Sunday, January 25, 2009 2:33 PM


All replies