locked
Hp w2207h display not working properly. RRS feed

  • Question

  • Hey.  I just recently bought an hp w2207h monitor(very shiny and nice) to go with my zt system with vista home premium.  When i plug in my monitor and turn the computer on it usually say "NO SIGNAL" and goes to sleep mode.  I know it is not the monitor problem since i plug it in to an older pc i had.  Also it usually turn on and work normally after i reset the computer several time. Is there any suggestion or ideas.  Please i am growing frustrated and about to strap dynamites to my motherboard and send it on it ways.  Thank you.
    Monday, January 19, 2009 1:27 AM

Answers

  • Good morning again!

    I think the relevant bios settings are the ones below, and recommend checking the Asus site (http://www.asus.com/) for information on bios configuration.

    1.
    ACPI (this is chip-level power control)
    see: bios menus and Advanced Configuration and Power Interface (http://en.wikipedia.org/wiki/Advanced_Configuration_and_Power_Interface)

    2.
    Boot sequence (disk order, network boot)
    see: bios menus

    Regards,
    Bill Wesse
    MCSE, MCTS / Senior Escalation Engineer, US-CSS DSC PROTOCOL TEAM


    Escalation Engineer
    Tuesday, January 20, 2009 1:39 PM

All replies