Problem with my code when debugging in VS2010 vs VS2012.


  • I can debug my INTEL Fortran code in VS2010 with no problem.  If I try to debug my IFC in VS2012, I am getting a subscript out of range error.

    I am running on Windows 10.  Compiling with IFC 2013 or 2015, both work fine in VS2010 debugger, but not in VS2012 Debugger.

    Thursday, November 29, 2018 12:16 AM

All replies

  • Hi issallisbs,

    Do you install the Intel Visual Fortran Composer XE 2013 in order to support VS2012?

    As far as I know, different VS versions require different Fortran Compilers.

    Since it is related to the Intel Visual Fortran, you could also get suggestion in the following forum:

    Note: This response contains a reference to a third party World Wide Web site. Microsoft is providing this information as a convenience to you. 
    Microsoft does not control these sites and has not tested any software or information found on these sites;
    Therefore, Microsoft cannot make any representations regarding the quality, safety, or suitability of any software or information found there.
    There are inherent dangers in the use of any software found on the Internet, and Microsoft cautions you to make sure that you completely understand the risk before retrieving any software from the Internet.

    Best Regards,


    MSDN Community Support
    Please remember to click "Mark as Answer" the responses that resolved your issue, and to click "Unmark as Answer" if not. This can be beneficial to other community members reading this thread. If you have any compliments or complaints to MSDN Support, feel free to contact

    Friday, December 7, 2018 7:24 AM