none
Communication problem using umxdot11.exe

    Question

  •     Hi, everyone.

        I have the problem to communicate between two sora station using umxdot11.exe, the config of which is 11b,1000kbps.

       The command I used is

       -dut start

       -%Sora_path/UMXdot11.exe tx/rx

        but the output of rx terminal is "receive 0 correct frame, the throughput is 0.000Mbps".

        Could you tell me the correct command to use umxdot11.exe? And what is your cmd output? Is there sth. I missed?

        Hope for your reply. 

    Wednesday, May 23, 2012 1:50 AM

Answers

  • The problem has been resolved...

    The command in the tx terminal

               -dut start

               -dut centralfreq --value 2422

               -dut txgain --value 0x1000

               -%Sora_path/UMXdot11.exe tx

    The command in the rx terminal

              -dut centralfreq --value 2422

              -dut rxpa  --value 0x2000

              -dut rxgain --value 0x2000

               -%Sora_path/UMXdot11.exe rx

    Thank you for your attention.

    • Marked as answer by henrylrc Wednesday, May 23, 2012 2:30 AM
    Wednesday, May 23, 2012 2:30 AM

All replies

  • The problem has been resolved...

    The command in the tx terminal

               -dut start

               -dut centralfreq --value 2422

               -dut txgain --value 0x1000

               -%Sora_path/UMXdot11.exe tx

    The command in the rx terminal

              -dut centralfreq --value 2422

              -dut rxpa  --value 0x2000

              -dut rxgain --value 0x2000

               -%Sora_path/UMXdot11.exe rx

    Thank you for your attention.

    • Marked as answer by henrylrc Wednesday, May 23, 2012 2:30 AM
    Wednesday, May 23, 2012 2:30 AM
  • Hi henrylrc,

    Thank you for sharing your experience.

    -Jiansong

    Saturday, June 2, 2012 4:13 AM
    Moderator