Remote UPnP setup not completing properly RRS feed

  • General discussion

  • I have converted to a new Cable servcie and a new Router was installed.  A Netgear CGD24G was updated during the WHS Remote set up process.

    The UPnP table was set up and remote access worked.  It took a while and the new router failed the IGDEvaluator version 1..3.5.0 report showed UPnP support was not supported.

    You might need to contact Netgear to see why the failure is occuring. 


    • Changed type Tom Grundy Friday, December 24, 2010 1:51 AM Notification of Hardware issue
    Friday, December 24, 2010 1:50 AM

All replies