Remote Control does not work on all clients RRS feed

  • Question

  • Hello,

    we want to run WWT on a 9 channel projection system and experienced a problem:

    I installed WWT on all clients and the master.
    When launching WWT via Remote Control only the computers for channel 3 and channel 4 react.
    On the other computers WWT does not open (and also not on the master), although the Remote Control icon is visible in the task bar of each computer.
    The MAC addresses are entered correctly, but I think they are only used for WakeUp anyway.

    What could be the cause?

    Is there a log-file which I can analyze to find the error?

    Questions about the slave computer setup:

    On the help page for the slave computer setup the "Install the WWTRemoteControl" link does not work.

    Under 5. the instructions say: Record the IP address for each slave."
    Why? It doesn't look like they are used later on in the instructions. Is there a place where I have to enter these ip addresses?

    Thank you very much for your help!


    Monday, January 7, 2013 10:51 AM


All replies