locked
how start using ICE RRS feed

  • Question

  • I'm a newbie. How do I use ICE?

    Wednesday, December 17, 2014 3:37 AM

Answers

  • Hi there,

    1. Install it, if possible use the 64 bit version. It's free.

    2. ICE starts with a new blank project. Drag and drop  your photos (ideally snapped side by side with 15 degree overlap between them). It's ok to throw in any closeup snaps as well as ICE will draw higher resolution from these additional photos. It automatically starts stitching them together for you.

    3.  Perform any adjustments. Crop the final stitch if needed.

    4. Export it as a picture or upload to www.photosynth.net. Microsoft ID needed but it will also upload your raw photos and give you a clickable "walk through".

    Done.

    My opinion - ICE does great work and the algorithms included are much better than any other free stitching software I have used. try the video pano but uploading your video instead to create a still panorama.


    • Marked as answer by Dr.Ron Wednesday, December 17, 2014 9:36 PM
    Wednesday, December 17, 2014 6:06 AM

All replies

  • Hi there,

    1. Install it, if possible use the 64 bit version. It's free.

    2. ICE starts with a new blank project. Drag and drop  your photos (ideally snapped side by side with 15 degree overlap between them). It's ok to throw in any closeup snaps as well as ICE will draw higher resolution from these additional photos. It automatically starts stitching them together for you.

    3.  Perform any adjustments. Crop the final stitch if needed.

    4. Export it as a picture or upload to www.photosynth.net. Microsoft ID needed but it will also upload your raw photos and give you a clickable "walk through".

    Done.

    My opinion - ICE does great work and the algorithms included are much better than any other free stitching software I have used. try the video pano but uploading your video instead to create a still panorama.


    • Marked as answer by Dr.Ron Wednesday, December 17, 2014 9:36 PM
    Wednesday, December 17, 2014 6:06 AM
  • Thanks. rrn

    Wednesday, December 17, 2014 9:37 PM